Sunme
Electronic component supply
Direct supplies from leading global manufacturers
PCB design
Printed circuit board design of any complexity
Software development
Embedded systems and microprocessor software
Import substitution
Replacing foreign components with Russian analogues
Supplier audits in China
On-site factory and supplier verification in China
Integrated supplies
Full cycle from components to finished product
Discuss project →
AboutCasesKnowledge baseFAQGlossary
RUConsultation
Sunme

Directions

Electronic component supplyPCB designSoftware developmentImport substitutionSupplier audits in ChinaIntegrated supplies
AboutCasesKnowledge baseFAQGlossary
RUSwitch language
Consultation
Sunme

Electronic component supply and technology solutions for your manufacturing

Services

  • Component supply
  • PCB design
  • Software development
  • Import substitution
  • China audit
  • Integrated supplies

Company

  • About us
  • Cases
  • Knowledge base
  • Careers
  • Contacts

Support

  • FAQ
  • Glossary
  • Privacy policy
  • Legal details

Subscribe to newsletter

Engineering materials, guides and cases every two weeks

© 2026 Sunme. All rights reserved.

Privacy policy
← Microbase|Microbase
Главная/Стабилизаторы и DC-DC/PWM контроллеры/SG3525

SG3525

Texas InstrumentsVerifiedDIP-16

Аналоги и замены (1)

OEM part number

SG3525

Texas Instruments

Стабилизаторы и DC-DC · PWM контроллеры

CN part number

SG3525AN

TI/ST

Стабилизаторы и DC-DC · PWM контроллеры

VerifiedPin-to-PinDIP-16
Vcc=8-35ВFsw=400кГцIout=500мАSoft-startUnder-voltage lockout

Комментарии об отличиях

SG3525 ↔ SG3525AN

SG3525AN — оригинальный PWM controller от TI/ST. Pin-to-Pin сам с собой. Voltage-mode PWM controller: Vcc=8-35В, Fsw до 400кГц, output drive 500mA totem-pole, встроенный soft-start (внешний конденсатор на pin 8), Under-voltage lockout при Vcc<8V. Reference=5.1В ±1%. Dead-time control (pin 5), SYNC output (pin 3). Два выхода (OUT_A, OUT_B) для push-pull/bridge. Error amplifier с access на pins 1,2,9. Shutdown через pin 10 (или pin 8 через SCR latch). Критический параметр: pulse-by-pulse current limiting через pin 4 (Current Sense). Для полумоста/пуш-пула — классический выбор. Подходит для DC-DC, инверторов, UPS

Информация предоставлена в справочных целях. Перед внедрением любого аналога обязательно сверьте технические характеристики, температурные режимы и сертификаты безопасности в актуальных даташитах производителей. Ответственность за финальный выбор компонента и его применение несёт инженер.