Sunme
Electronic component supply
Direct supplies from leading global manufacturers
PCB design
Printed circuit board design of any complexity
Software development
Embedded systems and microprocessor software
Import substitution
Replacing foreign components with Russian analogues
Supplier audits in China
On-site factory and supplier verification in China
Integrated supplies
Full cycle from components to finished product
Discuss project →
AboutCasesKnowledge baseFAQGlossary
RUConsultation
Sunme

Directions

Electronic component supplyPCB designSoftware developmentImport substitutionSupplier audits in ChinaIntegrated supplies
AboutCasesKnowledge baseFAQGlossary
RUSwitch language
Consultation
Sunme

Electronic component supply and technology solutions for your manufacturing

Services

  • Component supply
  • PCB design
  • Software development
  • Import substitution
  • China audit
  • Integrated supplies

Company

  • About us
  • Cases
  • Knowledge base
  • Careers
  • Contacts

Support

  • FAQ
  • Glossary
  • Privacy policy
  • Legal details

Subscribe to newsletter

Engineering materials, guides and cases every two weeks

© 2026 Sunme. All rights reserved.

Privacy policy
← Microbase|Microbase
Главная/Интерфейсы/LVDS интерфейсы/DS90LV049

DS90LV049

Texas InstrumentsVerifiedSOP-8

Аналоги и замены (1)

OEM part number

DS90LV049

Texas Instruments

Интерфейсы · LVDS интерфейсы

CN part number

RS2049

Run-IC

Интерфейсы · LVDS интерфейсы

VerifiedPin-to-PinSOP-8
400Mbps LVDS dual differential line driver/receiver

Комментарии об отличиях

DS90LV049 ↔ RS2049

DS90LV049 (TI) — dual LVDS differential line driver + receiver, SOP-8, 400Mbps (200MHz), 3.3V supply, low power 25mW typical. RS2049 (Run-IC) — pin-to-pin аналог DS90LV049, SOP-8, LVDS driver + receiver. Поддержка до 400Mbps, 3.0-3.6V supply. LVDS output: VOD 250-450mV, VOS 1.125-1.375V. Input threshold: ±100mV. Propagation delay: typ. 2.5ns. Потребление: ~30mW при 3.3V. Прямая замена для LVDS интерфейсов: LCD панели, камеры, FPGA interconnect. Важно: LVDS требует controlled impedance traces (100Ω differential) и termination resistor 100Ω на приёмнике.

Информация предоставлена в справочных целях. Перед внедрением любого аналога обязательно сверьте технические характеристики, температурные режимы и сертификаты безопасности в актуальных даташитах производителей. Ответственность за финальный выбор компонента и его применение несёт инженер.