Sunme
Electronic component supply
Direct supplies from leading global manufacturers
PCB design
Printed circuit board design of any complexity
Software development
Embedded systems and microprocessor software
Import substitution
Replacing foreign components with Russian analogues
Supplier audits in China
On-site factory and supplier verification in China
Integrated supplies
Full cycle from components to finished product
Discuss project →
AboutCasesKnowledge baseFAQGlossary
RUConsultation
Sunme

Directions

Electronic component supplyPCB designSoftware developmentImport substitutionSupplier audits in ChinaIntegrated supplies
AboutCasesKnowledge baseFAQGlossary
RUSwitch language
Consultation
Sunme

Electronic component supply and technology solutions for your manufacturing

Services

  • Component supply
  • PCB design
  • Software development
  • Import substitution
  • China audit
  • Integrated supplies

Company

  • About us
  • Cases
  • Knowledge base
  • Careers
  • Contacts

Support

  • FAQ
  • Glossary
  • Privacy policy
  • Legal details

Subscribe to newsletter

Engineering materials, guides and cases every two weeks

© 2026 Sunme. All rights reserved.

Privacy policy
← Microbase|Microbase
Главная/Интерфейсы/Интерфейсы/AW9523

AW9523

AwinicNeeds adaptationQFN-24

Аналоги и замены (1)

OEM part number

MCP23017

Microchip

Интерфейсы · Интерфейсы

CN part number

AW9523

Awinic

Интерфейсы · Интерфейсы

Needs adaptationPartialQFN-24
I2C 16-bit GPIO/LED driverinterrupt2.5-5.5V

Комментарии об отличиях

MCP23017 ↔ AW9523

MCP23017 (Microchip) ↔ AW9523 (Awinic) [QFN-24, GPIO/LED]: Отличия: MCP23017 — pure 16-bit I/O expander (GPIO), все 16 линий конфигурируются как input/output независимо, INTA/INTB interrupts, 3 адресных пина (8 адресов), internal pull-up 100kΩ. AW9523 — 16-bit LED driver + GPIO controller hybrid: каждый пин может быть LED mode (constant current source, 256-step dimming, IMAX=37mA) ИЛИ GPIO. Это фундаментальное отличие! AW9523 НЕ имеет internal pull-ups/pull-downs в GPIO mode. P0 port — open-drain по умолчанию (требует external pull-up), P1 — push-pull. INT pin (active LOW) есть у обоих. Адаптация: 1) Переписать firmware — другие register map и I2C команды. 2) Если нужны pull-ups — добавить внешние. 3) Проверить default state после power-on (зависит от AD0/AD1 у AW9523). 4) LED mode — бонус, но требует отдельной конфигурации.

Информация предоставлена в справочных целях. Перед внедрением любого аналога обязательно сверьте технические характеристики, температурные режимы и сертификаты безопасности в актуальных даташитах производителей. Ответственность за финальный выбор компонента и его применение несёт инженер.